3D Wingmaster

  This is a overview of my SMD PCB assembly setup. PCB The PCBs and stencil have arrived back from DirtyPcb. Initial there was a problem ...

  Finally finished the PCB design of the pinball IO board. It did cost me more time as expected to squeeze all the tracks on the board.  I ...

  I finally started on the hardware design. This will make it easer to start testing playfield parts. The pinball will be driven by the fo...

  What would be the best way to make a playfield? There are so many ways to do this. Playfield constructions In general there seems to be...

  A filament extruder is a device that melts plastic granules to make filament for a 3d printer. When I started this project, 3d printer fi...

  While surfing the internet, I came across the Fire Action pinball. The translite: The playfield. Playfield design It looked very f...

  Toolflow There are still several playfield part to be designed, but I also like to start designing the playfield to check placement and ...

  Spinner are targets on the playfield that spin when the ball hits them. They will slow the ball down slightly, but will not stop them. T...

  I did receive several request to publish my design, but have not made up my mind if i do that and how. In any case if i publish the files...

  Also known as ball locks or saucers. These are parts of the playfield, where the ball falls in a hole. The ball stays there till the ball...